Fujitsu ETERNUS AF250 S2 - Drive Enclosure Drives

2.1.1 Installing Power Distribution Unit (1U)
This section describes how to install the 1U power distribution unit in a rack.
1 Remove the two brackets temporarily attached to the power distribution unit.
Remove the two M3 screws from the front of the power distribution unit to free the brackets.
Power distribution unit
Bracket B
Bracket A
M3 screw
M3 screw
2 Attach the brackets and holders to the rack.
(Rack pillar: rear)
Bracket B
Screw
holder
M6 screw
Screw
holder
Bracket A
Holder
Holder
M6 screw
The four M6 screw positions for the brackets are determined relative to the power distribution unit base
line.
The four M6 screws should be inserted in the 1st and 3rd holes above the base line.
Power distribution unit1U
(Rack pillar: rear)
Bracket
Power distribution unit
base line
1st hole
(M6 screw)
3rd hole
(M6 screw)
1st hole
(M6 screw)
3rd hole
(M6 screw)
[Left] [Right]
Chapter 2 Rack Installation
2.1 Power Distribution Unit Installation (for Regions other than the EMEIA, Central American, and Caribbean Regions)
24
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0