5.2.3 Powering On
Turn on the PC terminal and the ETERNUS AF.
Follow the procedure below to turn on the ETERNUS AF
.
•
After turning the power on, it takes approximately five minutes for the
ETERNUS AF to reach the READY
state (READY LED (
) turns on). If an error is detected in a component during the initial power-on
diagnostics, it may take a longer time (up to 10 minutes, or up to 11 minutes for a configuration in
which the Deduplication/Compression function is enabled) for the
ETERNUS AF to reach the READY state.
If a scheduled operation is being performed, make configurations by taking the operation into consider-
ation.
•
After power-off, wait for about one minute before turning power on again.
•
If the ETERNUS AF is not turned off normally due to problems such as a power failure, it takes approxi-
mately five minutes (max.) longer to reach the READY state the next time the ETERNUS AF is turned on.
1 Press the Power switch of the controller enclosure.
Controller enclosure
Power switch
The POWER LED ( ) of the controller enclosure and the POWER LEDs ( ) of the drive enclosures are
turned on.
2 After approximately five minutes, check that the READY LED ( ) of the controller enclosure is lit up.
Controller enclosure
Drive enclosure
When checking the connection between the PC terminal and the ETERNUS AF, execute the "ping" com-
mand at the PC command prompt. An example of ping execution is shown below. ("192.168.1.1" is the
default IP address for the ETERNUS AF)
ping 192.168.1.1
If the execution results in an error, check the network settings of the PC terminal.
Chapter 5 General Settings
5.2 Powering On
61
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
