Fujitsu ETERNUS AF250 S2 - Additional Drive Installation Procedure

2 Connect the controller enclosure to the drive enclosure.
(1) Connect Controller 0 first.
Connect the DI (OUT) port of Controller 0 (CM#0) in the controller enclosure to the DI (IN) port of
I/O module 0 (IOM#0) in the drive enclosure with the mini SAS HD cable between enclosures.
Controller
enclosure
Drive
enclosure
(2) Connect Controller 1 next.
Connect the DI (OUT) port of Controller 1 (CM#1) in the controller enclosure to the DI (IN) port of
I/O module 1 (IOM#1) in the drive enclosure with the mini SAS HD cable between enclosures.
Controller
enclosure
Drive
enclosure
4.3 Power Synchronized Unit Connection
When using a power synchronized unit for power control, connect the power synchronized unit to the ETER-
NUS AF.
Refer to "Configuration Guide (Power Synchronized Unit)" for details about power synchronized units, the pro-
cedure for connecting power synchronized units to the
ETERNUS AF, and required settings.
4.4 Power Cord Connection
Connect the power cords to the ETERNUS AF.
Chapter 4 Connecting Cables
4.3 Power Synchronized Unit Connection
49
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0