Chapter 6
Monitoring Settings
Perform the ETERNUS AF monitoring setup if required.
For details on the settings, refer to "Configuration Guide (Web GUI)".
6.1 Event Notification Setup
Select whether to report events detected in the ETERNUS AF. There are six methods for event notification:
Host Sense Key Code Qualifier, SNMP Trap, E-Mail, Syslog, REMCS, and AIS Connect.
The event notification setting is explained below.
1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2 In [Category], click [Event/Dump].
The [Event/Dump] screen appears.
3 In [Action], click [Setup Event Notification].
The [Setting based on Severity] tab screen of the [Setup Event Notification] screen appears.
4 In the [Setting based on Severity] tab screen, select the required items.
5 On the screens that are displayed by clicking each level tab, select the required items.
85
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
