5.4 Storage Management (Initial Setup 1)
Perform the settings that are required before operation of the ETERNUS AF by using the Initial Setup 1 screen
of ETERNUS Web GUI.
Perform the following settings according to the wizard screen:
•
Set Storage System Name
•
Change User Password
•
Set Thin Provisioning
•
Register SED Authentication Key
•
Setup Network Environment
The procedure for the initial setup is shown below. For details on the settings, refer to "Configuration Guide
(Web GUI)".
1 Click the [Next >>] button in the [Initial Setup] screen.
The [Set Storage System Name] screen appears.
2 ETERNUS AF
name setup
Set the name of the ETERNUS AF as well as other information.
The information that is set here is used for network management by SNMP. The name of the ETER-
NUS AF
is displayed in the login and operation screens of ETERNUS Web GUI.
Chapter 5 General Settings
5.4 Storage Management (Initial Setup 1)
64
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
