• Enter the domain name or IP address of the Syslog server in "Domain Name /IP Address".
(2) Click the [Set] button.
A confirmation screen appears.
(3) Click the [OK] button.
Setting of the audit log starts.
(4) Check the setting completion message and click the [Done] button.
The screen display returns to the [Audit Log] screen.
6.5 Monitoring Server (SNMP Manager) Settings
Install and set up the monitoring software on the server side.
Refer to the manual for the monitoring software to install and set the monitoring software.
Register the file that was downloaded in "Download the MIB file" (Step 6) in "
6.2.1 SNMP Trap Setup"
(page 86) as the MIB definition file for the monitoring software.
Chapter 6 Monitoring Settings
6.5 Monitoring Server (SNMP Manager) Settings
101
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
