3 Install the power distribution unit in the rack.
Fasten the power distribution unit to the bracket with the two M3 screws removed in Step 1.
(Rack pillar: rear)
M3 screw
M3 screw
4 Attach the blank panel to the front side of the rack.
The blank panel should be attached at the same height as the power distribution unit.
(Rack pillar: rear)
(Rack pillar: front)
Blank panel
Power distribution unit
Chapter 2 Rack Installation
2.1 Power Distribution Unit Installation (for Regions other than the EMEIA, Central American, and Caribbean Regions)
25
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
