■
When Checking Using the ETERNUS Multipath Driver
The following procedure explains how to check LUNs with the ETERNUS Multipath Driver.
1 Click the [Start] button, expand [ETERNUS Multipath Driver] from [All Programs], and open [ETERNUS
Multipath Manager].
2 Confirm that the same number of LUNs are displayed as the number of LUNs that are set.
If the LUNs for the
ETERNUS AF storage systems are recognized by the server, the devices (LUNs) in the
ETERNUS AF storage systems are displayed under LUN and Disk Number.
The host interface (CA) numbers of the ETERNUS AF are displayed on ETERNUS Multipath Driver as
shown below.
CM#0 CA#0 Port#0 g CAID = 00 CM#1 CA#0 Port#0 g CAID = 02
CM#0 CA#0 Port#1 g CAID = 01 CM#1 CA#0 Port#1 g CAID = 03
CM#0 CA#1 Port#0 g CAID = 20 CM#1 CA#1 Port#0 g CAID = 22
CM#0 CA#1 Port#1 g CAID = 21 CM#1 CA#1 Port#1 g CAID = 23
Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
129
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
