■
When Controlling by the Power Switch
This section explains how to use the Power switch to turn off the
ETERNUS AF.
1 Press and hold the Power switch of the controller enclosure for four seconds or more.
Controller enclosure
Power switch
The READY LED ( ) on the controller enclosure is turned off.
• After power-off, wait for about one minute before turning power on again.
• If the Power switch is pressed again between the time of the READY LED ( ) turning off and the
POWER LED ( ) turning off, the ETERNUS AF power may turn on.
2 The power of the ETERNUS AF
is disconnected.
When the power is disconnected, the POWER LED (
) of the controller enclosure and the POWER LEDs
( ) of the drive enclosures are turned off.
■
When a Power Synchronized Unit Is Used
If the server is turned off, the
ETERNUS AF is also turned off.
Chapter 10 System Status Check
10.6 Powering Off
157
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
