■
Configuration Procedure
Install any plug-ins that are required for VMware linkage and perform the necessary settings.
● Required Environment
For linkage with vSphere Web Client, ETERNUS vCenter Plug-in is required.
For linkage with VASA, ETERNUS SF Storage Cruiser and ETERNUS VASA Provider are required.
● Configuration Procedure
vCenter
Install ETERNUS vCenter Plug-in in a Windows server where VMware Web Client Server is installed.
•
Server-side settings
Install ETERNUS vCenter Plug-in and then register the ETERNUS AF as a management target device.
•
Settings for the
ETERNUS AF
Enable SSH connections in the firewall settings of the network settings in ETERNUS Web GUI.
For mode details on the settings for ETERNUS vCenter Plug-in, refer to "ETERNUS vCenter Plug-in User's
Guide".
VASA Provider
Install ETERNUS VASA Provider in the storage management server in which ETERNUS SF Storage Cruiser is op-
erating.
•
Settings for ETERNUS VASA Provider
Install ETERNUS VASA Provider in the storage management server.
Perform the settings that are related to ETERNUS VASA Provider in the vCenter Server after installation.
•
Settings for ETERNUS SF Storage Cruiser
Before starting the ETERNUS VASA Provider service, register ESXi Server and the ETERNUS AF that is to be
monitored in ETERNUS SF Storage Cruiser.
Update the configuration file and enable linkage with the device event information to apply the ETERNUS
VASA Provider settings.
For more details on the settings for ETERNUS VASA Provider, refer to "ETERNUS VASA Provider User's Guide".
For more details on the settings for ETERNUS SF Storage Cruiser, refer to "ETERNUS SF Web Console Manual"
and "ETERNUS SF Storage Cruiser Operation Guide".
Chapter 11 Solution Configuration
11.3 Virtualization Platform
166
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0
To Next Page
Loading...
