Fujitsu ETERNUS AF250 S2 - Power Distribution Units (Regions); 1 U Power Distribution Units

2 Install the power distribution unit in the rack.
Fasten it to the prepared holes in the pillars with eight M5 screws.
(Rack pillar: rear)
M5 screw
M5 screw
3 Attach the blank panel to the rack front.
The blank panel should be attached at the same height as the power distribution unit.
(Rack pillar: rear)
(Rack pillar: front)
Blank panel
Power distribution unit
Chapter 2 Rack Installation
2.1 Power Distribution Unit Installation (for Regions other than the EMEIA, Central American, and Caribbean Regions)
27
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0