Fujitsu ETERNUS AF250 S2 - Basic Operation; Powering On and Off; Power Distribution Unit Switches

4 Install the controller enclosure in the rack.
Do
• When installing or removing the controller enclosure to or from the rack,
make sure that the sides and the bottom of the controller enclosure are held
by two or more people. Failure to do so may cause injury.
5 Fasten the controller enclosure in the rack.
Use three M5 screws to fasten it in the rack pillar.
M5 screw
M5 screws
6 Attach the flange cover.
Chapter 2 Rack Installation
2.2 Controller Enclosure Installation (for Regions other than the EMEIA, Central American, and Caribbean Regions)
30
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0