Fujitsu ETERNUS AF250 S2 - Page 43

Usage Protocol tcp / udp
Port
number
Direction
Master CM Slave CM
Remarks
MNT RMT MNT RMT
REMCS
(remote support)
smtp tcp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
Used for
failure
notifica-
tion, etc.
http (cli-
ent)
tcp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
Used for
firmware
down-
load, etc.
AIS Connect (remote
support)
https (cli-
ent)
tcp 443 to
¡ (*2) ¡ (*2)
´ ´
—
Syslog
(event notification
and audit log send-
ing)
Syslog udp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
−
RADIUS Radius udp Must be
set
to
¡ (*2) ¡ (*2)
´ ´
−
ping ICMP − − from
¡ (*2) ¡ (*2)
´ ´
−
KMIP (key manage-
ment)
SSL tcp 5696
(*3)
to
¡ (*2) ¡ (*2)
´ ´
−
ETERNUS DX Discov-
ery
Unique
protocol
udp 9686 from
¡
´ ´ ´
−
¡: Possible / △: Partially possible / ´: Not possible
*1: Only the following functions are available:
• Checking the ETERNUS AF status
• Switching the Master CM
*2: May use either the MNT port or RMT port.
*3: Modifiable
For details on the port numbers for the ETERNUS SF Software, refer to the manual of each Storage Foundation
Software ETERNUS SF.
■
Communication Modes
The default LAN operation mode is "Auto Negotiation" which allows the
ETERNUS AF to automatically recog-
nize 1000BASE-T/100BASE-TX/10BASE-T and Full/Half-Duplex connections. However, some devices may re-
quire that a fixed communication mode be set.
Chapter 3 Checking the Configuration Environment
3.4 LAN Connection Preparation for Operation Management
43
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0