Fujitsu Eternus DX600 S3 - Page 822

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
822
• CHAP Password
• Confirm CHAP Password
● Host Setting
• iSCSI Name
A.4.2.3 Add SAS Host Group
For details about this function, refer to "4.2.3 Add SAS Host Group" (page 379).
For the factory default settings for this function, refer to "Appendix B Add SAS Host Group" (page 993)
.
● Host Group Setting
• Host Group Name
Description Specify the password for the CHAP Authentication.
It is not necessary to specify this item if the CHAP Authentication is not used.
Make sure to set the user name and password together.
Only when the "Change CHAP Password" checkbox is selected, the field is available.
Input condition/
Display contents
• 12 - 100 alphanumeric characters and symbols (except "," (comma) and "?")
• Spaces
Description Input the CHAP password again for confirmation.
Only when the "Change CHAP Password" checkbox is selected, the field is available.
Input condition/
Display contents
• 12 - 100 alphanumeric characters and symbols (except "," (comma) and "?")
• Spaces
Description Input the iSCSI name of the iSCSI host (required).
Input condition/
Display contents
• 4 - 223 alphanumeric characters and symbols ('-', '.', ':')
• The name starts with "iqn." or "eui."
For setting items, refer to Step (2) (page 374)
.
Description Specify the host group name.
An existing host group name cannot be used. Refer to "Naming conventions for adding
hosts" (page 1053) for details.
Input condition/
Display contents
• Up to 16 alphanumeric characters and symbols (except "," (comma) and "?")
• Spaces