Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
823
• Host Response
• Checkbox to select a host
● Host Setting
• SAS Address
A.4.2.4 Modify Host Group (FC/FCoE)
For details about this function, refer to "4.2.6 Modify Host Group (FC/FCoE)" (page 386).
● Host Group Setting
• Host Group Name
Description Select a host response that is to be assigned to a host group.
The host response list created in the ETERNUS DX is displayed.
Input condition/
Display contents
• Solaris MPxIO
• HP-UX
• AIX
• AIX VxVM
• VS850/SVC
• BS2000
• Host responses created in the ETERNUS DX
• Default
The LUNs that can be recognized from the host are determined by the "LUN Addressing" settings and the "LUN
Expand Mode (Peripheral Device Addressing)" settings for the host response. When a host that has the host affinity
setting is added to a new host group, check the LUN setting state. If a LUN that is LUN#256 onward is used for the
host, the relevant host cannot be added to a host group with "256 LUN" for the host response. Refer to "Host
responses and recognizable LUNs" (page 818) for details.
Description Select the SAS host checkbox to be registered in a host group.
Input condition/
Display contents
Checkbox
• Selected
• Cleared
Description Input the SAS address for the SAS host.
Input condition/
Display contents
• Hexadecimal numbers (0 - 9, A - F, a - f)
• 16 digits ("F (f)" or "0" used in entire 16 digits are not allowed)
Description Specify the host group name.
An existing host group name cannot be used. Refer to "Naming conventions for adding
hosts" (page 1053) for details.
Input condition/
Display contents
• Up to 16 alphanumeric characters and symbols (except "," (comma) and "?")
• Spaces
To Next Page
Loading...
