Fujitsu Eternus DX600 S3 - Page 864

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
864
● Send ping (IP address)
• IP Address
• Send Number
• Result
A.4.3.8 Modify SAS Port Parameters
For details about this function, refer to "4.3.9 Modify SAS Port Parameters" (page 454).
For the factory default settings for this function, refer to "Appendix B Modify SAS Port Parameters" (page 998)
.
● Port Settings
• Port
Description Input the IPv4 or IPv6 address of the storage system that is used to check the connection
status of the target port.
The following IPv6 addresses can be used; "link local address", "global address", "unique
local address", or "6to4 address". Refer to "Available IPv6 Address" (page 107)
for
details. When the current setting is displayed, the IPv6 address is displayed as an
abbreviation.
Input condition/
Display contents
• For IPv4 address
- xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
- Class must be A, B, or C
• For IPv6 address
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.
Description Input the transmission count of the "ping" command.
Input condition/
Display contents
1 (Default) - 10
Description Click the [Send] button to display the results of the "ping" commands that are sent.
Input condition/
Display contents
• success
All were sent successfully.
• failed
At least one failure occurred.
Description Select the target port or select the copy source port.
The selectable port locations are displayed as options.
Input condition/
Display contents
CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)