Fujitsu Eternus DX600 S3 - Page 865

Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
865
• Transfer Rate
• Reset Scope
• Release Reservation if Chip is Reset
A.4.3.9 Modify FCoE Port Parameters
For details about this function, refer to "4.3.10 Modify FCoE Port Parameters" (page 455).
For the factory default settings for this function, refer to "Appendix B Modify FCoE Port Parameters" (page
999).
● Port Settings
• Port
Description Select the transfer speed for the target port.
Input condition/
Display contents
• Auto-negotiation
• 1.5 Gbit/s
• 3 Gbit/s
• 6 Gbit/s
Description Specify the reset scope of the target port.
Reset scope is the range where the command reset request from the server is performed,
when the target port is connected to multiple servers.
Input condition/
Display contents
• I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset
request.
• T_L (T: Target, L: LUN)
Reset (cancel) the command request from all of the servers that are connected to the
port.
Description Select whether to "Enable" or "Disable" the function to release the reserved status of the
volume when the target port (chip) is reset.
Input condition/
Display contents
• Enable
• Disable
Description Select the target port or select the copy source port.
The selectable port locations (x: CE number, y: CM number, z: CA number, w: Port
number) are displayed as options.
Input condition/
Display contents
• For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y CA#z Port#w
• For the other models
CM#y CA#z Port#w