Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
893
• Redundant Port
• IP Address
• Subnet Mask
• Gateway
• IPv6 Link Local Address
Description Select which redundant port is used for the multipath configuration of the target port. If
a multipath configuration is not used, select "None".
When a multipath configuration is not used for the target port, "ports without NAS
interface settings", "single ports with NAS interface settings", and "None" are displayed
as options. Ports in a different CM from the target port are displayed as redundant ports.
Note that bonding ports (or member ports for Bonding) are not displayed.
If a multipath configuration is already used for the target port, a redundant port is
displayed.
This item is available when a port is specified.
Input condition/
Display contents
When a multipath configuration is not used for the port:
• Ports without NAS interface settings
• Single ports with NAS interface settings
• None
When a multipath configuration is used for the port:
• Redundant ports
Description Input the IPv4 address of the target port.
Input condition/
Display contents
• xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
• Class must be A, B, or C.
Description Input the subnet mask of the target port.
Input condition/
Display contents
192.0.0.0 - 255.255.255.252
Description Input the IPv4 gateway address of the target port.
Input condition/
Display contents
• xxx.xxx.xxx.xxx
xxx: 0 - 255 for all the text boxes (decimal)
• Class must be A, B, or C.
Description Input the IPv6 link local address of the target port.
Input condition/
Display contents
fe80::xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
for details.
To Next Page
Loading...
