Fujitsu fi-8190

Setting Item Description Parameter(*1)/Value Factory Default
(*2)
- : No parameters/values
17:Manual
Feed Timeout
Specify a waiting time for scanning
documents manually.
It can also be configured in the Software
Operation Panel.
5, 10, 20, 30, 40, 50, 60,
70, 80, 90, 100, 110
(seconds)
10
18:Paper
Protection
Configure the setting to detect feeding
errors.
This function detects feeding errors in the
following cases:
● When the scanner detects an abnormal
document skew caused by a feeding
error
● When the scanner detects paper jam
noise
Paper jams due to feeding errors could
damage or tear valuable documents.
Detecting a feeding error and stopping the
scan can prevent damage to documents.
This function is effective when you scan
documents which are difficult to feed such
as thin paper documents.
Specify the sensitivity level for detecting
feeding errors when the paper protection
function is enabled.
Documents are skewed abnormally or
paper jam noise is made when documents
are not being fed properly.
Specify the sensitivity level to detect an
abnormal document skew or paper jam
noise.
The paper protection setting can also be
configured in the scanner driver or the
Software Operation Panel.
When the paper protection setting is set to
on in the scanner driver, [Feeding Skew &
Noise] is enabled regardless of the setting
on the Software Operation Panel.
For the paper protection setting, priority
will be given in the following order:
1:Disable
2:Feeding Skew
3:Feeding Noise
4:Feeding Skew & Noise
Skew Sensitivity:
1:Normal
2:High
Sensitivity for feeding
noise:
1:Low
2:Normal
3:High
4:Feeding Skew &
Noise
Skew Sensitivity:
1:Normal
Sensitivity for
feeding noise:
2:Normal
How to Use the Operator Panel [fi-8190/fi-8290/fi-8170/fi-8270]
165