Fujitsu M10 - Page 22

Table 1-4
Workflow for the SPARC M10-4S (continued)
Step (work time (*1)) Work description Reference
15 Log in to the SPARC M10-4S, and
check the firmware version number,
altitude setting, and time setting.
"6.3 Logging In to the XSCF"
"6.4 Checking the XCP Version"
"6.5 Checking the Altitude Setting"
"6.6 Checking the Time Setting"
Required
16 Perform an initial diagnosis test on the
physical system board (PSB).
"6.7 Performing a Diagnosis Test" Required
17 Check the status of mounted
components.
"6.8 Checking the Component
Status"
Required
Initial system settings (approx. 92 minutes)
18 Set the password policy. "7.1 Setting the Password Policy" Required
19 Set a user account and password. "7.2 Setting a User Account and
Password"
Required
20 Configure the telnet or SSH service. "7.3
Configuring the Telnet/SSH
Service"
Required
21 Configure the HTTPS service. "7.4 Configuring the HTTPS
Service"
Required
22 Configure the XSCF network. "7.5 Configuring the XSCF
Network"
Required
23 When duplicating memory, configure
memory mirroring.
"7.6 Configuring Memory
Mirroring"
Optional
24 Create the PPAR configuration
information (PCL).
"7.7 Creating a Physical Partition
Configuration List (PCL)"
Required
25 Assign the system
board (PSB) to the
physical partition.
"7.8 Assigning a System Board
(PSB) to a Physical Partition (PPAR)"
Required
26 Set a CPU operational mode for the
physical partition.
"7.9 Setting a CPU Operational
Mode for the Physical Partition"
Optional
27 Clear the difference between the
system time and physical partition
(PPAR) time.
"7.10 Synchronizing
the Physical
Partition (PPAR) Time and XSCF
Time"
Required
28 Add a CPU Activation key to the
system.
"7.11 Registering a CPU Activation
Key"
Required
(*4)
29 Assign CPU resources to the physical
partition.
"7.12 Assigning CPU Core
Resources"
Required
30 Confirm the start/stop of the physical
partition and the connection of the
console.
"7.13
Starting and Stopping a
Physical Partition (PPAR)"
Required
*1 Average work time for the 4BB configuration
*2 Time required for mounting optional components is not included.
*3 If the optional components are ordered together with the chassis, they are shipped mounted to the chassis.
*4 One CD-ROM disk containing a CPU Activation certificate is provided with the system. The system
may be shipped with a registered
CPU Activation key.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 20158