Fujitsu M10 - Page 71

Table 2-13
Electrical specifications (Expansion rack: Single-phase power feed model) (*1) (continued)
Item Specification
1 expansion rack 2 expansion racks
Input voltage 200 to 240 VAC 200 to 240 VAC
Leakage current (*3) (*4) 3.5 mA 3.5 mA
*1 The specifications apply to a single rack.
*2 For the M10-4S mounted in an expansion rack. If the mounted device is not the M10-4S, the configuration may be different depending
on the power connection configuration of the device.
*3 The value is the tolerance per power cord. The actual current value
depends on the rating of the device mounted in the expansion rack.
*4 The value is for an expansion rack without the M10-4S and other devices mounted. (Only crossbar boxes are mounted.)
Only the two power cords use power.
If the M10-4S or other devices are mounted, the current values and
the number of power cords that consume power are different.
*5 The current that flows through each power cord in a redundant configuration is half the value listed in Table 2-13.
Table 2-14
Electrical specifications (Expansion rack: Three-phase delta power feed model) (*1)
Item Specification
1 expansion rack 2 expansion racks
Input voltage 200 to 240 VAC 200 to 240 VAC
Number of power cords 6 6
Power cord length 4.0 m (13.1 ft.) 4.0 m (13.1 ft.)
Redundancy (*2) 1+1 redundant configuration 1+1 redundant configuration
Frequency 50 Hz/60 Hz 50 Hz/60 Hz
Rated current (*3) Maximum of 35 AMaximum of 35 A
Rated current (*4) (*5) 4.0 A5.2 A
Maximum power consumption (*4) 1,354 W1,754 W
Apparent power (*4) 1,382 VA 1,790 VA
Rush current (*3) (*4) 80 A
peak or less 80 A peak or less
Leakage current (*3) (*4) 3.5 mA 3.5 mA
*1 The specifications apply to a single rack.
*2 For the M10-4S mounted in an expansion rack. If the mounted device is not the M10-4S, the configuration may be different depending
on the power connection configuration of the device.
*3 The value is the tolerance per power cord. The actual current value
depends on the rating of the device mounted in the expansion rack.
*4 The value is for an expansion rack without the M10-4S and other devices mounted. (Only crossbar boxes are mounted.)
Only the two power cords use power.
If the M10-4S or other devices are mounted, the current values and
the number of power cords that consume power are different.
*5 The current that flows through each power cord in a redundant configuration is half the value listed in Table 2-14.
Table 2-15
Electrical specifications (Expansion rack: Three-phase star power feed model) (*1)
Item Specification
1 expansion rack 2 expansion racks
Input voltage 380 to 415 VAC 380 to 415 VAC
Number of power cords 6 6
Power cord length 4.0 m (13.1 ft.) 4.0 m (13.1 ft.)
Chapter 2 Planning and Preparing for System Installation 57