RX200 S3 Operating Manual 31
Hardware Installation Installing/Removing the Server in/from the Rac
4.2 Installing/Removing the Server in/from the
Rack
V CAUTION!
● Please note the safety instructions in chapter “Important Infor-
mation” on page 17 and section “Notes on Installing in the
Rack” on page 26.
● At least two people are needed to position the server into/out of
the rack.
● The rack can tip over when more than one slide-in module is
pulled out.
● The server may not occupy the top height unit of the rack (38 HU/42
HU PRIMECENTER Rack and/or DataCenter Rack), as otherwise
boards or fans cannot be replaced even with the plug-in module fully
extended.
Rack requirements
The rack systems of the Fujitsu Siemens Computers (PRIMECENTER Rack
and DataCenter Rack) support fully the installation of the PRIMERGY server
systems. Installation in most current rack systems from other manufacturers
(3rd party racks) is also supported.
To accommodate the ventilation concept and ensure proper ventilation, any
unused areas in the rack must be sealed using dummy covers.
The power is supplied via the multiple socket outlets fitted in the rack.
The main features of the rack systems of the Fujitsu Siemens Computers are:
To Next Page
Loading...
Need help?
General
