RX200 S3 Operating Manual 61
7 Troubleshooting and Tips
V CAUTION!
Observe the safety information in the “Safety” manual and in the
chapter “Important Information” on page 17.
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the attached devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps performed and the circumstances that led to the fault.
Also make a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team.
7.1 Power On Indicator Remains Unlit
The power-on indicator remains dark after you switch on your device.
Power cable incorrectly connected
Ê Make sure that the power cable(s) is/are correctly connected to the server
and the grounded socket(s).
Power supply overloaded
Ê Disconnect the server power plug(s) from the power socket(s).
Ê Wait a few seconds before you plug it/them into the grounded socket(s)
again.
Ê Switch on your server.
To Next Page
Loading...
Need help?
General
