72 Operating Manual RX200 S3
Hot-pluggable hard disk drives Hot plug components
8.2.3 Installing/Removing the HDD Module
V CAUTION!
Under no circumstances should you remove an HDD module while the
system is in operation if you are not sure whether the hard disk drive is
operated by a RAID controller and belongs to a disk array which is
operating at RAID level 1 or 5.
V CAUTION!
All HDD modules (drives) must be uniquely identified so that they can be
reinstalled in their original mounting locations after they have been
removed. If this is not done, existing data can be lost.
I Several prefabricated stickers with the storage capacities are provided
with the server so the storage capacity of the hard disk can be recog-
nized at a glance when the HDD module is replaced. A sticker corre-
sponding to the capacity should be applied to the front of each hard drive
(HDD module) (position 5 in figure 18 on page 73). In case no suitable
sticker is available, blank stickers for labeling are also provided. The
stickers are color-coded to make identification easier.
To Next Page
Loading...
Need help?
General
