64 Operating Manual RX200 S3
No Mouse Pointer Displayed on Screen Troubleshooting and Tips
7.6 No Mouse Pointer Displayed on Screen
Mouse driver not loaded
Ê Check whether the mouse driver is properly installed and is activated when
the application program is started. Detailed information can be found in the
user manuals for the mouse, the operating system and the application
program.
Mouse controller disabled
The mouse controller on the system board must be enabled if you are using the
mouse supplied.
Ê Check in the SetupUtility D1350 that the mouse controller is Enabled.
7.7 Incorrect Date and Time
Ê Set the time and/or date in the operating system or in BIOS Setup.
I If the time and date are repeatedly wrong when you switch on your
server, you must change the lithium battery. Contact our Service group.
7.8 System Will Not Boot
The system will not boot after installing a new hard disk drive.
SAS configuration incorrect
Ê Check the settings for the hard disk drives (SAS Device Configuration) and the
additional settings in the SAS configuration menu.
To Next Page
Loading...
