RX200 S3 Operating Manual 53
Startup and Operation Switching the Server On and Off
5.2 Switching the Server On and Off
V CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see section “Flickering
Stripes on Monitor Screen” on page 63).
The ON/OFF button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug(s).
Switching the server on
The Power on indicator (position 6 in figure 11 on page 45) lights orange
(standby mode).
– Starting up for the first time:
Ê Press the ON/OFF button (position 9 in figure 11 on page 45).
Ê Insert the ServerStart CD and/or an installation disk in the corresponding
drive.
Ê Follow the on-screen instructions (see also section “Configuration with
ServerStart” on page 55 or section “Configuration without ServerStart”
on page 56).
– System already installed:
Ê Press the ON/OFF button (position 9 in figure 11 on page 45).
The server is switched on, performs a system test and boots the
operating system.
Switching the server OFF
Power on indicator (position 6 in figure 11 on page 45) lights green.
Ê Shut down the operating system in an orderly manner.
Ê Press the ON/OFF button (position 9 in figure 11 on page 45) and/or send a
corresponding control signal (see “Other on/off options” on page 54).
The server switches OFF and remains in standby mode.
To Next Page
Loading...
Need help?
General
