Fujitsu Primergy RX300 S2 User Manual

89
PRIMERGY RX300 S2 User’s Guide
3
OS Installation Using ServerStart
■ Checking Server Free Space
Decide a server to use as a remote resource server / PXE server and check it for enough free space for
storing resources.
● Checking the Number of Servers
• When you have only one server, use it as the remote resource server, PXE server, and DHCP service
server. Check it for the required amount of free space.
• When you have multiple servers
• Check if a server performing the DHCP service exists. If not, decide a server for the DHCP
service.
• When there are multiple resources, they can be divided and stored in multiple remote resource
servers.
● Checking Server Free Space
The following table shows the amount of free space required for each installation resource.
Calculate the total resource size. Check that the remote resource server / PXE server has enough free
space (free space greater than the space required for the resources). When the amount of free space is
insufficient, you must use more remote resource servers.
table: Free Space Required for Resources
Resource
Required free
space
ServerStart About 650MB
Windows Server 2003 644MB
Windows 2000 Server 472MB
Windows 2000 Service Pack 4 433MB

Fujitsu Primergy RX300 S2 Specifications

General

Processor Sockets	2
Chipset	Intel 5000P
Network	2 x Gigabit Ethernet
Form Factor	2U Rackmount
Processor	Intel Xeon 5000/5100/5300 series
Storage	SAS or SATA HDD 2.5"/3.5"
RAID Support	Optional RAID controller
Operating System Support	Windows Server, Linux
Power Supply	Redundant power supply optional