Fujitsu Primergy RX300 S2

155
PRIMERGY RX300 S2 User’s Guide
5
Operations after OS Installation
2 The installer starts up. Proceed the installation by following the window
instructions.
When the window below appears during the installation procedure, check [BASP] and click
[Next].
5.6.2 Load Balance
Once a Windows Server 2003 or Windows 2000 Server Team is created, virtual adapters (BASP Virtual
Adapter) will be created in the [Device Manager] and/or [Network and Dial-up Connections] of the
system. Do not disable or delete a virtual adapter from the [Device Manager] or [Network and Dial-up
Connections]. When deleting a virtual adapter, make sure to use BACS.
■ Load Balance Setup Procedure
1 Start up BACS. The procedure differs depending on the OS being used.
For Windows Server 2003
1. Click [Start] → [Control Panel] → [Broadcom Control Suite 2].
For Windows 2000 Server
1. Click [Start] → [Settings] → [Control Panel].
The [Control Panel] window appears.
2. Start up "Broadcom Control Suite 2".