237
PRIMERGY RX300 S2 User’s Guide
8
Hardware Configuration/Utilities
8.2.9 Power On/Off Submenu
Appears when [Power On/Off] is selected from the [Advanced] menu.
Configures power On/Off settings.
table: Items on the Power On/Off Submenu
Item Setting Description
Power Off Source - -
Software • Disabled
• Enabled (at the time of
purchase)
Sets whether or not to enable the power to be turned
off using a program or the operating system.
Power Button • Disabled
• Enabled (at the time of
purchase)
Sets whether or not to allow the use of the power
switch for turning the power off, when the ACPI
function is disabled.
Power On Source • BIOS Controlled (at the
time of purchase)
• ACPI Controlled
Sets to turning the power on.
Remote • Disabled
• Enabled (at the time of
purchase)
Sets whether or not the power is turned on when the
modem (connected to the serial port) receives a ring
signal.
LAN • Disabled
• Enabled (at the time of
purchase)
Sets whether or not to enable the power to be turned
on via LAN.
Wake Up Timer Disabled (Fixed parameter) Sets whether or not the power is turned on at a
certain time or after a certain time has passed.
Item Specific Help
F1
Esc
Select Item
Select Menu
Change Values
Select Sub-Menu
-/+
Enter
Info
Exit
F9
F7
Setup Defaults
Previous Values
PhoenixBIOS Setup Utility
Advanced
Power Off Source
Software: [Enabled]
Power Button: [Enabled]
Power On Source: [BIOS Controlled]
Remote: [Enabled]
LAN: [Enabled]
Wake Up Timer: [Disabled]
Wakeup Up time: [00:00:00]
Power Failure Recovery: [Previous State]
Power On/Off
Wakeup Up Mode: [Daily]
To Next Page
Loading...
Need help?
General
