Fujitsu Primergy RX300 S2 User Manual

90
Chapter 3 OS Installation Using ServerStart
3.4.3 Preparation of the PXE Server (When the PXE Server
is Used)
When performing remote installation using a PXE server, preparatory procedures, such as installing
ServerStart, are required.
Perform the following procedures to prepare the PXE server.
■ Starting the DHCP Service
Check that the DHCP service is running on the same network.
If the DHCP service function is not installed, perform the following procedures (for Windows Server
2003) to install the DHCP service.
1 Click [Start] → [Control Panel] → [Add or Remove Applications].
2 Click [Add or Remove Windows Components]. Click the [Dynamic Host
Configuration Protocol (DHCP)] service from [Network Services].
The DHCP service is installed.
3 Create and configure a DHCP scope so that the IP address can be distributed.
Starting the DHCP Service
Installing ServerStart
Checking Services
Setting TFTP
Preparation of Resources

Fujitsu Primergy RX300 S2 Specifications

General

Processor Sockets	2
Chipset	Intel 5000P
Network	2 x Gigabit Ethernet
Form Factor	2U Rackmount
Processor	Intel Xeon 5000/5100/5300 series
Storage	SAS or SATA HDD 2.5"/3.5"
RAID Support	Optional RAID controller
Operating System Support	Windows Server, Linux
Power Supply	Redundant power supply optional