EasyManua.ls Logo

Fujitsu Primergy RX300 S2

Fujitsu Primergy RX300 S2
311 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
Chapter1 Overview
1.4.5 Inserting and Ejecting a CD-ROM
This section explains how to insert and eject a CD-ROM.
Cautions for Handling CD-ROM Drive
Use the drive in a dry place with low airborne dust levels. Entry of water, a paper clip, or other liquids
or metal objects can cause electric shock or failures.
Do not use the drive in a place exposed to shocks or vibration.
Do not insert any object other than the specified CD-ROMs.
Do not pull or push the CD-ROM tray forcibly.
Do not disassemble the CD-ROM drive.
Clean the CD-ROM tray before use. Use a dry, soft cloth for cleaning.
When the CD-ROM drive is not used for a prolonged period, eject the CD-ROM to prevent accidents.
To avoid dust or particles, keep the CD-ROM tray closed (in a loaded position).
This server supports CD-ROMs with the following logo. Do not use CD-ROMs without the logo.
Doing so may cause failures.
Cautions for Handling CD-ROMs
When removing the disk from the case, pull the disk up while pressing the center holder of the case as
shown in the figure below.
Hold the CR-ROM on its edge to avoid contact with the disk surface.
Do not contaminate the CD-ROM surface with fingerprints, oil, or dust. If the disk is dirty, wipe it
from the center to the edge with a dry, soft cloth. Do not use benzine, thinner, water, record sprays,
antistatics, or silicone clothes.
Be careful not to scratch the CD-ROM surface.
Avoid heat.
Do not bend the floppy disk or place heavy objects on it.
Do not use a ball-point pen or pencil on the label (printed) side.
Do not apply stickers to the label side. Abnormal vibration can occur due to eccentricity.
When the CD-ROM is moved from a cold place into a warm place, dew condensation may occur,
resulting in data read errors. If this is the case, wipe droplets away with a dry, soft cloth and let the
unit dry naturally. Do not use a hair dryer.
To avoid dust, scratches, or deformation, store CD-ROMs in the case whenever not in use.
Do not store CD-ROMs in areas of high temperature exposed to direct sunlight for many hours or
near heating appliances.

Table of Contents

Other manuals for Fujitsu Primergy RX300 S2

Related product manuals