Fujitsu Primergy RX300 S2 - Page 35

35
PRIMERGY RX300 S2 User’s Guide
1
Overview
■ Inserting the Floppy Disk
1 Insert the floppy disk into the floppy disk drive from the shutter side.
When clicking into place, the floppy disk eject button pops out.
■ Ejecting the Floppy Disk
1 Make sure that the floppy disk access LED is off. Press the floppy disk eject
button.
The floppy disk is ejected.
• Do not eject the floppy disk while the floppy disk access LED is on. The data
stored on the floppy disk may be damaged.
Floppy disk
eject button
Shutter
Label side up
Floppy disk access LED
Off
Floppy disk eject button