RX300 S3 Operating manual 35
Hardware Installation Installing/Removing the Server into/from the Rac
Requirements of the rack
The rack systems of the Fujitsu Siemens Computers (PRIMECENTER Rack
and DataCenter Rack) support fully the installation of the PRIMERGY server
systems. The installation into the at present usual rack systems of different
foreign manufacturers (3rd-Party Rack) is supported to large part.
To accommodate the ventilation concept and ensure proper ventilation of the
components in the rack, any unused areas must be closed using dummy covers.
The power is supplied via the socket strips available in the rack.
The main features of the rack systems of the Fujitsu Siemens Computers are:
PRIMECENTER Rack
– Frontally bolted telescopic rails.
The rails are provided with a linear alignment possibility to ensure also an
adjustment to different rack depths.
– Extended cable management within the lateral rack area.
DataCenter Rack
– Frontally bolted telescopic rails (except within the rear left area where a
support bracket is used).
– Extended cable management within the lateral rack area.
The mounting of the rails in the different racks is described in the next sections.
The mounting of the cable management is described in detail in the Technical
Manual to the respective rack.
To rack systems of different foreign manufacturers the following applies:
To Next Page
Loading...
