Troubleshooting and tips
Acoustic warnings
Acousticerror messagesErrors
Cause
Troubleshooting
A beep sounds every few secon d s.
The battery is almost flat.
► Charge the battery.
Error messages on the screen
Errormess agesont he sc
reen
Errormessage:
This section describes the e rro r messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact th e place of purchase or o ur customer service centre.
Error message/cause Resolution
CMOS ba ttery bad
If the error message occurs repeatedly, the
buffer battery in the Tablet PC is fl at.
► Contact your sales outlet or our customer
service centre.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
► Switch off the Tablet PC.
► Switch on the Tablet PC.
► Keep the
tablet button pressed
and switch the Tablet PC on.
► In the BIOS Setu
p, select the Exit menu.
► Select the entry Load Setup D efaults.
► Select OK and p
ress the Enter key.
Extended mem
ory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testin
g the extended memory an error has
resulted a
t the address xxxx.
► Contact your sales outlet or our customer
service centre.
Failure F
ixed Disk n
The setti
ngs of the ha rd disk drive are incorrect.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
Keyboar
d controller error
► Switch off y our Tablet PC with the ON/OFF
switch.
► Wait 3 - 5 seconds and switch on the Tablet
PC again.
Keyboard error
If you are using an external k eyboard:
► Check the co nnection and reboot the Tablet
PC.
nn Stuck key
► Make sure that no key is pressed.
74 Fujitsu
To Next Page
Loading...
Need help?
General