1-1
1. INSTALLATION
1.1 Equipment List
1.2 How to Install the Display Unit
The display unit can be installed on a desktop or flush mounted in a console. Do not
install the unit on the overhead or a bulkhead. Select a suitable location for the unit
considering the following points:
Desktop mount
Fasten the unit to the mounting location as shown below. For mounting dimensions,
see the outline drawing at the back of this manual.
Name Type Code No. Qty Remarks
Display Unit RDP-157 — 1
Antenna Unit RTR-120 — 1
Mounting Base RTR-120 — 1
Installation Materials
CP03-37600 000-033-122
Select
one
CP03-37610 000-033-123
CP03-37620 000-033-124
Radome Mounting Bracket OP03-209 001-078-350 1 Option
External Buzzer OP03-21 000-030-097 1 Option
NMEA Data Converter IF-NMEA2K2 000-020-510 1
Junction Box FI-5002 000-010-765 1
Cable Assy. FRU-CF-FF-30M 001-464-290 1
Flush Mount Kit OP03-242 0001-464-280 1 Option
Do not use paint, anti-corrosion products, contact spray or
other items containing organic solvents on the equipment.
Organic solvents can harm paint and plastic, particularly the con-
nectors.
• Select a location where the controls can be easily operated.
• Locate the unit away from the direct wind from air conditioners.
• The temperature range in the mounting location should be -15°C(5°F to 55°C(131°F).
• Locate the unit away from devices that emit active gas.
• The mounting location must be well ventilated.
• Select a location where vibration and shock are minimal.
• A magnetic compass will be affected if the display unit is placed too close to the com-
pass. Observe the compass safe distances in the safety instructions to prevent inter-
ference to the compass.
• Locate the unit away from direct sunlight to prevent heat build up inside the cabinet
and condensation in the display.
• Keep the unit away from water and water splash. (The unit complies with waterproofing
specification IP5.)
To Next Page
Loading...
