2-1
2. WIRING
2.1 Wiring
Use the supplied cable FRU-CF-F01 to connect a satellite compass, heading sensor,
GPS navigator, external buzzer, and power supply to the 12-24 VDC/NMEA connec-
tor.
Connect the antenna cable (FU-CF-xxM (10m/15m/20m/30m) to the antenna port.
See the interconnection diagram at the back of this manual for details. Leave slack in
the cable to ease maintenance.
Display unit, rear view
Note 1: The display unit comes with connector caps. Use the caps to cover the con-
nectors whenever the display unit is removed from the boat.
Note 2: Cut unused wires and wrap them with vinyl tape to keep them from touching
one another.
Note 3: Use care when disconnecting cables to prevent damage to their connectors.
Note 4: If an NMEA device is to use +12 V power from this radar, do not connect the
device’s circuit GND or chassis GND. (Do not connect chassis GND to 12V_M.)
Ground
Ship’s switchboard,
external equipment,
ground terminal, etc.
Power/signal connector
Antenna cable
䠄FRU-CF-FF-**M, 10/15/20/30m䠅
To Next Page
Loading...
