Furuno 1815 - Waypoint Marker

5. OPERATION
5-52
5.36 Waypoint Marker
The waypoint marker shows the location of the destination waypoint set on a naviga-
tion plotter. The heading signal or course data are required. You can turn on/off the
waypoint marker as follows:
Waypoint marker
1. Press the MENU/ESC key to open the menu.
2. Use the Cursorpad ( or ) to select [Others] and press the ENTER key.
3. Use the Cursorpad ( or ) to select [WPT Mark] and press the ENTER key.
WPT Mark options
4. Use the Cursorpad ( or ) to select [Off] or [On] then press the ENTER key.
5. Press the MENU/ESC key to close the menu.
+
Waypoint
marker