7. TT OPERATION
7-7
6. Use the Cursorpad ( or ) to select [Past Posn Interval] and press the ENTER
key.
Past position interval options
7. Use the Cursorpad ( or ) to select the time interval and press the ENTER key.
8. Press the MENU/ESC key to close the menu.
7.8 TT Data
You can show the data or a TT in the data box at the bottom of the screen. To display
TT data, the menu item [Display] on the [TT] menu must be set for [On] and the menu
item [Data Box] on the [Display] menu must be set for [Target] or [All].
1. Use the Cursorpad to put the cursor on an TT.
2. Press the ENTER key to show the data of the target.
TT data
The symbol for the selected TT is enlarged double to distinguish from other symbols.
To remove the data of a target from a data box, put the cursor on its target symbol and
press the MENU/ESC key.
TRUE 05:00 <ARPA> No. 01
BRG
53.7°T
RNG 2.987NM CRS 350.4° SOG 23.45KN
CPA 1.65NM TCPA
06:14
Vector reference
Vector time
Target no.
Bearing, range, course, speed
CPA, TCPA
+
TT selected for
data display
01
TT
Data box
02
Cursor
To Next Page
Loading...
