3. INITIAL SETTINGS
3-4
• [Main Bang Suppression]: Reduce the main bang (black hole at center of screen),
which appears at the display center on short ranges, as follows.
1. Transmit on the shortest range.
2. Open the [Installation] menu and select [MBS Adjust].
3. Press the ENTER key to show the MBS adjustment window.
4. Press or on the Cursorpad so that the main bang is reduced.
5. Press the ENTER key to finish.
• How to automatically set the equipment: The tuning, timing, and video can be au-
tomatically adjusted as follows.
Note: Before doing this procedure, transmit the radar more than 10 minutes on a
long range and check that [Sector Blank] is [Off].
1. Transmit on the maximum range.
2. Open the [Installation] menu and select [Auto Initial Setup], then press the EN-
TER key.
3. Press on the Cursorpad to select [Yes], then press the ENTER key.
The tuning adjustment begins automatically, and the message "Tuning adjusting"
appears during tuning adjustment. After the tuning adjustment is completed, the tim-
ing and video are adjusted in that order. The messages "Timing adjusting" and "Vid-
eo adjusting" appear during those adjustments. After all adjustments are
completed, the window disappears. If the result for any item is not best for your con-
ditions, manually adjust the item according to the procedure in this section.
• [Total On Time]: You can set the total on time as shown below.
1. Open the [Installation] menu and select [Total On Time].
2. Press the ENTER key.
3. Press or on the Cursorpad to set value. The range is 000000.H to
999999.9 H.
4. Press the ENTER key to finish.
• [Total TX Time]: You can set the total TX time as shown below.
1. Open the [Installation] menu and select [Total TX Time].
2. Press the ENTER key.
3. Press or on the Cursorpad to set value. The range is 000000.H to
999999.9 H.
4. Press the ENTER key to finish.
• [Memory Clear]: The memory clear feature restores all settings to default, including
the default settings for the antenna connected to LAN.
1. Open the [Installation] menu and select [Memory Clear].
2. Press the ENTER key.
3. Press or on the Cursorpad to select [Yes], then press the ENTER key.
4. Press the ENTER key to finish.
To Next Page
Loading...
