1. INITIAL SETTINGS AND ADJUSTMENTS
1-13
5. Click the [Details] button to set the following items, referring to the table shown be-
low.
Data field Comments
[SFID] Keep the default setting.
Do not use the “AI” prefix (AIS excluded) or the “II” prefix.
[Data Type] Sets the RX sentence data format.
Setting options: [IEC 61162-1 Ed3], [IEC 61162-1 Ed4], [IEC 61162-1
Ed5], [ASCII], [BINARY], [MODBUS], [PSU]. Do not select [ASCII] or
[BINARY].
[Strict/Loose] Sets the integrity of sentence data.
[Strict]: Confirm the validity of checksum, then receive sentence.
[Loose]: Receive sentence regardless of checksum invalidity.
Item Remarks
[Sensor Name] Enter the appropriate sensor name.
[Manufacture] Select the manufacturer of sensor from the pull-down list.
Note: If the required manufacturer does not appear, add it
manually (see section 1.4.9).
[Sensor Type No.] Select the type of sensor from the pull-down list.
Note: If the required type does not appear, add it manually
(see section 1.4.9).
[System Alert ID] The identification number that is assigned in the system is
shown in this field. Do not change the setting.
[X (m)], [Y (m)], [Z (m)] Set the location of X, Y and Z for [Other Sensor] only.
[Alert Information Source] Set the source of alert definition to show on the display
when the alert message is received in an ALF sentence.
• [Alert Definition]: Show the alert definition registered to
the PCU.
• [Alert Sentence]: Show the alert definition included in the
ALF sentence.
For [Other Sensor]
For [VDR]
For other units
To Next Page
Loading...
