Furuno FMD-3100 - Activating the Connection with the Processor Unit of the FAR-2 Xx8 Series Radar

1. INITIAL SETTINGS AND ADJUSTMENTS
1-19
1.4.3 Activating the connection with the processor unit of the FAR-
2xx8 series radar
1. Click [Radar] on the menu bar.
2. Check the check for each FAR-2xx8 series radar processor unit to be connected.
Setting range: [RAD111] to [RAD118]
The Equipment ID checked on this step is shown on the menu bar.
Note: Do not use [RAD001] to [RAD010].
3. Click the [Details] button to set the following items, referring to the table shown be-
low.
Item Remarks
[Equipment Name] Enter the name of the equipment.
[Equipment Type
No.]
Shows the equipment type number.
[SFID] Keep the default settings.
[System Alert ID] The identification number that is assigned in the system is shown
in this field. Do not change the setting.
RAD001 through RAD010 are not used.