1. INITIAL SETTINGS AND ADJUSTMENTS
1-80
1.16 How to Set the Forwarding Distance
Set the forwarding distance* as follows. The configuration can be copied to other units
connected to the network after saving the configuration.
*: The distance the ship travels straight after the steering control.
1. Press Ctrl, Shift and t keys simultaneously on the control unit or keyboard.
A dialog box for entry of password appears.
2. Enter the password and click the [OK] button.
Note: The edit mode is enabled until you press Ctrl, Shift and t keys simultane-
ously or reboot the unit.
3. Click [MENU] to open the menu.
4. Click [Navigation Parameter] to show the [Navigation Parameter] setting window.
5. Enter [SPD kn] (ship speed), [Radius NM] (turning radius) and [FWD DIST NM]
(forwarding distance*).
6. When [FWD DIST NM] is different between port and starboard sides, check the
checkbox of "Use different values for Port and Starboard" and then enter each set-
ting value.
7. Click [Save] button to save the configuration.
To Next Page
Loading...
