1. INITIAL SETTINGS AND ADJUSTMENTS
1-79
12. If you want to show the marks received from the ECDIS on the FAR-2xx8 screen,
open the main menu o [2 MARKS] o [6 ECDIS MARKS DISPLAY], then select
[ON] or [OFF] as appropriate.
13. Access the [Common Installation Setting] menu on the ECDIS.
14. Open the [Own Ship Setting] menu, then select [Radar Antenna] on the menu bar.
15. For one antenna unit, check [RAS001]. For two antenna units, check [RAS001]
and [RAS002].
For non-FURUNO radar
1. Open [Installation Parameters]o[Sensor Setting]o[Other Sensor] menu on the
ECDIS.
2. Check [OTR001] and enter “RA0201” in the [SFID] field. Do not use other than
[RA0201] to [RA0204].
Note 1: When entering the SFID, do not use the prefix "AI" (AIS excluded) or "II".
Note 2: Do not enter the same SFID as any other equipment in the network.
3. Select [Serial Input/Output] of the PCU you want to set on the menu bar.
4. Check the serial port to receive the TT symbol data and select “OTR001” from the
[Equipment ID] drop-down list.
The example shown below indicates that the [Serial 01] port of [ECD003] receives
the No.1 AIS data.
To Next Page
Loading...
