1. INITIAL SETTINGS AND ADJUSTMENTS
1-54
1.14 [Conning] Menu
The [Conning] menu configures the layout and data to show on the conning display.
Menu item Explanation
Items on the menu bar
[Conning (3x6)] Not used.
[Wide Conning (4x6)]
[Side Conning (1x9)]
[Mini Conning (1x5)] Consists of 5 blocks (1x5).
[Save/Import/Export] You can save the conning display data to a medium and load it
on the network.
[Decoder Define Im-
port/Export]
Not used.
[Decoder Import/Ex-
port]
Not used.
Items in the view area
[Name] Not used.
[Show] Not used.
[Copy From] Not used.
[Components] Select the components to show on the conning display. The
components are available in three sizes: [Small], [Medium],
[Large]. The [Small] components occupy one block. The [Medi-
um] components occupy two blocks. The [Large] components
occupy three or more blocks. Check the size of the component
to show on the [Components] window. Select the component
and click it to show the component on the [Layout] window.
[Layout] You can configure the layout and data to show on the conning
display. Drag and drop the components to configure the layout.
Click to delete a component from the [Layout] window. To se-
lect the data source for a component, click to display the
advanced settings window. See the procedure on
section 1.14.1.
Save / Import / Export
Decoder Define Import / Export
Decoder Import / Export
To Next Page
Loading...
