1. INITIAL SETTINGS AND ADJUSTMENTS
1-36
3. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.7.2 Master/Backup AMS setting
Set the master and backup AMS among the units connected to AMS. The master AMS
outputs the alert data to the external AMS. When communication with the master AMS
is lost, the backup AMS outputs the alert data to the external AMS instead of the mas-
ter AMS.
Follow the procedure below to set master and backup AMS.
1. Access the [Common Installation Setting] menu, then select [AMS] from the tab
bar.
2. Select [AMS Main/Backup Setting] on the menu bar.
3. Select the Equipment ID from the pull-down list for [AMS Main] to assign the mas-
ter AMS.
Note: The FMD-3100 cannot be assigned as master or backup AMS. Assign an
ECDIS other than the FMD-3100 as the master and backup AMS.
[Buzzer Pattern] Sets the buzzer sound pattern to output when an alert occurs.
[INS]:
• Alert priority = “Alarm”: Three short beeps, four seconds mute,
then repeat.
• Alert priority = “Warning”: Two short beeps, four seconds
mute, then repeat.
[Legacy]:
• Alert priority = “Alarm” or “Warning”: Alarm sounds continuous-
ly.
[Transfer Category]
(A~C)
Check the checkbox of the appropriate Category (A to C) to
transfer the alerts.
[Stop Transfer Cate-
gory A ACK]
Select [YES] to enable stopping of the alert transfer for Category
A alerts by ACK operation. In this case, the alert is not acknowl-
edged.
[Transfer Alerts to
BNWAS]
Set the permissions for the alert transmission to BNWAS (Bridge
Navigational Watch Alarm System). The unit(s) checked here are
allowed to output the alert signal to the BNWAS.
• [MFD]: Multifunction Display
• [ECD]: ECDIS
• [RAD]: Radar
• [CRA]: Chart Radar
item Remarks
To Next Page
Loading...
