Furuno FMD-3100 - Customized Sensor Setting

1. INITIAL SETTINGS AND ADJUSTMENTS
1-30
• [HUB Alert Setting] window ([Monitoring Type] = [Monitor Units])
5. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.4.9 Customized sensor setting
Set the sensor types and manufacturers in the [Sensor Setting] menu.
1. Click [User Sensor Model List] on the menu bar.
2. Click the appropriate sensor to edit. The figure below shows an example where
the [GPS Sensor] is selected.
Item Remarks
[Alert No.] When the alert notification sentence is ALR, the alert number is
shown.
When the alert notification sentence is ALF, the alert number and
the Instance ID are shown.
Click the [ ] button to open the [Alert No. Setting] window. Set
the output alert on the [Alert No. Setting] window. Check the radio
button for the desired alert and click the [OK] button.
[Alert Name] Name of the alert set for each port.
Drop-down list Select Equipment ID of device connected to HUB-3000.