Furuno FMD-3100 - How to Save the Configuration Data to a Medium

1. INITIAL SETTINGS AND ADJUSTMENTS
1-50
3) Check [Equipment ID] on the [System1] tab.
• Sensor adapter
If the Equipment ID of the sensor adapter is not correct, the alert shown below
appears.
"Sensor adapter: Sensor Adapter * COM Timeout" (* = 1 to 16)
If the Equipment ID is not correct, set the Equipment ID on the [Basic Setting]
menu (see section 1.2). At this time, turn off all units except the unit to be set, or
disconnect all LAN cables except the cable for PC.
1.10.2 How to save the configuration data to a medium
This function is only available through a LAN-connected PC. You can save the
configuration data to USB memory. Set the medium and then do as follows:
1. Select [Export] at the upper right of the [Save and Sync] menu.
The window shown below appears.
2. Select the configuration data type that you want to save, and then click [OK].
• [Sensor Setting]: Configuration data on the [Own Ship Setting], [Installation Pa-
rameters] and [CCRS] menu.
• [TCS Setting]: Configuration data on the [TCS] menu. Not used on FMD-3100.
• [AMS Setting]: Configuration data on the [AMS] menu.
• [Alert Setting]: Configuration data on the [Alert Define List] menu.
3. Select where to save the configuration data.
The file name "SettingFiles.tar" is created.
Click [Export].