1. INITIAL SETTINGS AND ADJUSTMENTS
1-58
• Graph
[Title]: Enter the title of the component.
[Type]: Set the graph type.
[Label Source]: Not used.
[Mode Source]: Not used.
[Label]: Enter the title of [Primary (Y1)] and [Secondary (Y2)] graph.
[Source]: Select the data source of [Primary (Y1)] and [Secondary (Y2)].
[Unit]: Set the unit used in [Primary (Y1)] and [Secondary (Y2)] graphs.
[Smoothing]: Select [Apply] to smooth the graph.
[Scale Ň Range]: Set the display range of the Y-coordinate. Three display ranges
can be entered.
[Time Span]: Set the display range of the X-coordinate.
[Sample Interval]: Set the interval of [Primary (Y1)] and [Secondary (Y2)] graph plot.
[Scale Resolution]: Select the scale resolution of the graph.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Decimal Num]: Select the number of digits after decimal point.
[Mathematical Sign (Scale)]: Check the checkbox to show the minus sign (-) when
the value of the Y-coordinate is minus.
[Mathematical Sign (Value)]: Check the checkbox to hide the minus sign (-) when
the value above graph is minus.
• Horizontal Bar
[Title]: Enter the title of the component.
[Left Source]: Select the data source of the value shown at the upper left of the bar.
[Center Source]: Select the data source of the value shown above the bar.
[Right Source]: Select the data source of the value shown at the upper right of the
bar.
• [(2x)Time/Y-graph]: The [Primary (Y1)] and [Secondary (Y2)] are used as Y-coor-
dinate for two independent graphs. The time is used as the X-coordinate for both
graphs.
• [(1x)X/Y-graph]: The [Primary (Y1)] input is used for the X-coordinate and the
[Secondary (Y2)] for the Y-coordinate.
To Next Page
Loading...
