3. HUB-3000 IGMP QUERIER SETTINGS
3-3
17. At the “Switch#” line, input “write” then press the Enter key. This will save the
configuration.
18. When the write process finishes, the HUB-3000 will restart.
19. Referring to steps 8 through 12, check to make sure the “Querier” line is showing
“Enabled”. If the “Querier” line shows “Disabled”, repeat the above procedure.
Switch# config
Switch_config# ip igmp-snooping querier
Switch_config# show ip igmp-snooping
Global IGMP snooping configuration:
-----------------------------------
Globally enable : Enabled
VLAN nodes : 1
Dlf-frames filtering : Enabled
Sensitive : Disabled
Querier : Enabled
Querier address : 10.0.0.200
Router age : 260 s
Response time : 15 s
Switch_config# write
Saving current configuration...
OK!
To Next Page
Loading...
