48
8 SD Card Information
Your F410 has two storage devices:
Internal storage that contains system files, and can hold .gcode files. This is called “card 0”.
For files uploaded through the network interface, card 0 is the default location.
External, removable SD card called “card 1”.
On Card 0, you should not add, delete, or modify any files outside of the “gcodes” directory beyond what
is described in this manual or as instructed by Fusion3 Customer Support. Doing so can result in your
F410 malfunctioning or not functioning at all. Card 0 MUST be installed in order for your F410 to
operate.
On card 1, there are no restrictions on adding, deleting, or renaming files.
If you are running a print from card 1, do not remove it from your printer while it’s running. If you do this,
the print job will fail.
To Next Page
Loading...
